JBL GO Battery extension
Recentlty, I scavenged a working JBL GO speaker, but with a dead battery. After using it few weeks in “wired mode”, I decided to replace it’s Lion battery.
Author: admin_tle
TankFC – Prototyping walk through
Detailed steps of my DIY flight controller prototype assembly and testing journey
Creating a Betaflight target from scratch
If you’re in the process of creating a new Betaflight board, this post will guide you to get a working betaflight target, from the STM32 pinout to the configuration file.
Designing my own Flight Controller
As an electronic engineer and FPV drone pilot, making my own flight controller has been a project around for a while. I finally get it done, so let’s dive into the design process of a Betaflight based flight controller.
Upside down BackPackerHD build
I’ve recently rebuild and modernized my BackPackerHD quad, with some hardware and software improvement.
DIY ND Filter for Runcam Split
3D printed adaptator for Runcam Split lens, using ROSCO professional ND filter.
TPU stack v1 testing
The TPU stack flies in my Flosstyle build for few months now, time to check how it’s going !
FPV Power Bank v2
After 6 months of use, here is what I modified on my compact FPV power bank.
TPU Stack v1 design
In this post, I will cover the design process of the TPU Stack, from parts selection to the assembly.
TPU Stack Introduction
When it comes to building a durable quad, people often think of making a stronger frame or adding motor guard. But other parts such as the stack are left as is. This project focus on the protection of those electronic parts.